Irrigation and water for tomato
- 1
Start from the Irrigation button Pick the plot and tap Irrigation. ORTH offers questions such as this week’s schedule, a water-quality check, or turning the water requirement into runtime for your system. Tap one to ask it. For tomato In a greenhouse, rain outside does not count. ORTH planned the water from the forecast ET₀ and the crop stage, in short daylight pulses for the sandy soil. - 2
Get this week’s schedule On Invernadero 1, we tapped Build this week’s irrigation schedule for this plot. ORTH planned 4 to 5 short pulses in daylight, 20 to 26 m³ per hectare a day, rising with ET₀ from 2.7 to 3.9 mm. For the week that is 136 m³ for the greenhouse, or 8.1 litres per plant, with the pulse times and the volume per pulse in the table. - 3
Read the operating rules Stop each pulse by the water meter until the system is calibrated. Inject the fertilizer in the middle of the pulse and finish with clean water. Hold the last pulse if the wetting bulb is still wet, and never catch up a shortfall late in the day: wet nights bring disease. ORTH rated the schedule four stars and asked for the measured dripper flow. - 4
Turn cubic metres into minutes per pulse We told ORTH there is one 1.9 L/h dripper per plant and all 16,800 plants run on one sector. It worked out the sector flow, 31.92 m³ per hour, and the minutes per pulse for each day, from 7.4 to 8.9, with the formula shown: pulse volume ÷ 31.92 × 60. If your controller only takes whole minutes, alternate neighbouring settings and check the day’s total on the water meter. - 5
Save the schedule as daily actions Ask ORTH to save the schedule with one action per day. Tap Review 7 Actions to see each day’s pulse times and controller setting, then tap Create 7 Actions. Each action also says not to catch up a missed pulse late in the day.
1.
2.
3.